CentOS 6.3 初次安装网络配置
1，修改静态网络配置# vim /etc/sysconfig/network-scripts/ifcfg-eth0DEVICE="eth0"BOOTPROTO="static"HWADDR="00:0C:29:99:5A:3C"NM_CONTROLLED="yes"ONBOOT="yes"TYPE="Ethernet"UUID="1cb095a6-b832-4dc1-92e1-1a1a7a58abc8"IPADDR="8.0.0.10"BROADCAST="8.0.0.255"NETMASK="255.255.255.0"NETWORK="8.0.0.0"GATEWAY="8.0.0.1"IPV6INIT="no"IPV6_AUTOCONF="no"
简化配置
# vim /etc/sysconfig/network-scripts/ifcfg-eth0DEVICE="eth0"BOOTPROTO="static"ONBOOT="yes"TYPE="Ethernet"IPADDR="8.0.0.11"BROADCAST="8.0.0.255"NETMASK="255.255.255.0"NETWORK="8.0.0.0"GATEWAY="8.0.0.1"IPV6INIT="no"IPV6_AUTOCONF="no"
2，修改DNS服务
# vim/etc/resolv.conf nameserver 8.0.0.1
3，重启网卡
# service network restartShutting down interface eth0: Shutting down loopback interface: Bringing up loopback interface: Bringing up interface eth0:
输出以上信息，代表成功了
or
# ifdown eth0; ifup eth0
同样OK
4，双网卡配置
# vim /etc/sysconfig/network-scripts/ifcfg-eth1DEVICE="eth1"BOOTPROTO="static"ONBOOT="yes"TYPE="Ethernet"IPADDR="192.168.0.10"BROADCAST="192.168.0.255"NETMASK="255.255.0.0"NETWORK="192.168.0.0"
页:
[1]